搜索资源列表
DEMOD
- 1.3寸OLED测试程序，4-SPI接口模式-1.3inch oled test code,4 bit serial interface
U8glib
- 使用U8GLIB库或SPI驱动OLED液晶屏,开发板 Arduino Mega 2560-Use U8GLIB library or SPI drive OLED LCD screen, development board Arduino Mega 2560
oled_spi
- 基于OK6410 spi驱动 OLED显示程序-Based OK6410 spi driver OLED display program
FLASHPOLED
- FLASH 快速读取OLED快速显示,由w25q16和OLED12864+STM32组成，亲测可用-fast transfer and display by using DMA of SPI,hard
ms5611Poled1306ssd-0.96
- 用51作为主机。ms5611气压传感器测量气压及温度并转化为高度，将数据用oled显示。包括软件模拟IIC及硬件SPI通讯方式。-With 51 as the host. Ms5611 barometric pressure sensor to measure air pressure and temperature and into a high degree, the data with oled display. Including software analog IIC and hard
FWLib
- OLED显示屏的SPI驱动C程序,下载了就能直接用，主控芯片是基于STm8的，非常好用-OLED display SPI driver C program, download can directly use, main control chip is based on the STm8, is very nice
Demo
- Adafruit_GFX和Adafruit_SSD1306这两个文件夹是库文件，请将其放入"libraries"文件夹内； Demo.ino为演示程序，正确接线并下载到Arduino板子上即可。 0.96寸SPI接口arduino接线方式： OLED屏 arduino开发板 GND GND VCC 3.3V 或5V SCL 10 SDA 9 RES 13 DC 11 CS 12 七针模块有cs脚；直接连接就好了；如果是用六针的CS默认已
OLED显示(模拟SPI总线)2
- 单片机nrf82532驱动液晶屏,使用串口驱动程序，很好是节约单片机输出口。(The single-chip nrf82532 drives the LCD screen and USES the serial driver, which is very good to save the single chip.)
实验26 - 1.8吋TFT彩屏显示
- OLED显示(硬件SPI驱动）,使用串口驱动程序，很好是节约单片机输出口。(OLED display (hardware SPI driver), using serial driver, very good is to save the single chip to export.)
OLED_SPI
- 这是SPI协议的OLED驱动代码,适合初学者学习.(This is the OLED driver code of the SPI protocol, suitable for beginners to learn.)
M242_C51_SPI_V1.0
- keil下的OLED单片机SPI通讯的参考例程。(The reference routine of the OLED microcontroller SPI communication under keil.)
OWL-IOT32V2-Demo-20170408
- 里面包含了基本的STM32F103的一些例子，包括USART、SPI、ADC、PWM、I2C、OLED等从简单到复杂(It contains some examples of basic STM32F103, including USART, SPI, ADC, PWM, I2C, OLED and so on, from simple to complex.)
1_开发板例程_Ver2_1
- MM32开发板活动资料 1 个标准的 JTAG/SWD 调试下载口 1 个电源指示灯（蓝色） 2 个状态指示灯（DS0:红色，DS1 :绿 色 ） 1 个 IIC 接口的 EEPROM 芯片，24C08，容量 1024 字节 1 个 SPI FLASH 芯片，S25F008A，容量为 1M 字节（即 8M bit) 1 个标准的 2.4/2.8/3.5/4.3/7 寸 LCD 接口，支持触摸屏 1 个 OLED 模块接口（与 LCD 接口部分共用） 1 个
中景园电子0.96OLED显示屏_STM32系列_SPI_例程
- 中景园电子0.96OLED显示屏_STM32系列_SPI_例程(China Jingyuan electronic 0.96OLED display _STM32 series _SPI_ routines)
串联型稳压电源
- 基于STM32F103的串联型稳压电源。普中的红外遥控输入设定电压， (SPI)TLC5615DA输出作为基准电压，AD用ADS1115，(IIC)OLED显示电压、电流。过流保护。输出0-12V。 附件包含原理图+程序+红外遥控按键说明(Based on STM32F103 series regulated power supply. The infrared remote control input set voltage, (SPI) tlc5615da output as the ref